Mobile splicing LED display is not loading properly, how to solve it?

  Nowadays, mobile splicing LED display can present a larger picture, stronger sense of three-dimensional, both indoor and outdoor can present a clear picture and other characteristics, which is widely used by various industries. And we use mobile splicing LED display in the process, sometimes there will be loading abnormal situation, thus bringing great inconvenience to our use. So do you knowMobile splicing LED displayLoading is not normal, how to solve it? The following Vishay Technology editorial is for you:

  Mobile splicing LED display loading is not normal solution:

  1, check whether the jumper cap is loose or off; if the jumper cap is not loose, please make sure the jumper cap is in the right direction.

  2, check and confirm the mobile splicing LED display used to connect the controller's serial line for the straight-through line, rather than cross-wire.

  3, check and confirm the mobile splicing LED display the serial port connection cable intact and no loose or off at both ends.

  4, against the mobile splicing LED display control software and their choice of control card to select the correct product model, the correct transmission mode, the correct serial port number, the correct serial transmission rate and against the software to provide the dial-switch diagram correctly set the control system hardware address bit and serial transmission rate.

  5. Make sure the control system hardware has been properly powered up.

  6, such as after the above checks and corrections, mobile splicing LED display still appears to load, please use a multimeter to measure, whether the connected computer or control system hardware serial port is damaged. To confirm whether the computer should be returned to the manufacturer or control system hardware will be returned to the test.

  In summary, is the mobile splicing LED display loading is not normal solution. However, due to the mobile splicing LED display loading is not normal cause is very complex, there may be the product itself, there may be in the use of the process of operation is not standardized caused by, so we need to go from a variety of factors to a comprehensive consideration in order to get a good solution.